Platinum Putter
Scotty Cameron putters?
I am looking to get a Scotty Cameron putter, because everyone talked about and finally I have the money. I'm looking for some of the older models, and I prefer to aviod collecters items. Does anyone know where I can find these classic putters classic terryllium Sea coast tour the Sea Newport two Pro Platinum Marking terrllium mid slope Newport 3.5 Tour Black Sea Newport 2 Tour Red Dot Circle T Newport 2 GSS any information is appreciated.
Golfsmith second-hand section has some older models to get a decent price .. as the study of stainless 199.99. but the amount is always limited so if you find the putter, just buy. I bought a second hand club (r7 tp fairway wood) from Golfsmith and clubs are in incredible condition. Also ebay is another option. GOOD LUCK: D
Snake Eyes Tour Platinum 7802 Putter Head
|
|
Snake Eyes Tour Platinum 7804 Putter Head (HAND: Right) $69.99 Snake Eyes Tour Platinum 7804 Putter Head : In four different body styles with three different neck designs, Snake Eyes Tour Platinum putters feature milled surfaces over their 304 soft stainless steel. The Advanced Roll Control (A.R.C.) milling pattern features a series of semicircle cuts, or scales, situated in a 44 upward angle. The width of each scale is 4 mm, compared to the average bal… |
|
|
Snake Eyes Tour Platinum 7802 Putter Head (HAND: Right) $69.99 Snake Eyes Tour Platinum 7802 Putter Head In four different body styles with three different neck designs, Snake Eyes Tour Platinum putters feature milled surfaces over their 304 soft stainless steel. The Advanced Roll Control (A.R.C.) milling pattern features a series of semicircle cuts, or scales, situated in a 44 upward angle. The width of each scale is 4 mm, compared to… |
|
|
Snake Eyes Tour Platinum 7801 Putter Head (HAND: Right) $59.98 Snake Eyes Tour Platinum 7801 Putter Head : In four different body styles with three different neck designs, Snake Eyes Tour Platinum putters feature milled surfaces over their 304 soft stainless steel. The Advanced Roll Control (A.R.C.) milling pattern features a series of semicircle cuts, or scales, situated in a 44 upward angle. The width of each scale is 4 mm, compared to the average bal… |
Write a comment: